專業雪櫃維修服務
解決所有凍櫃故障問題

自助處理方法：

1. 檢查溫度設定是否過高，調至適當溫度（冷藏4°C，冷凍-18°C）
2. 確認雪櫃門是否關緊，門封條是否損壞漏氣
3. 清理散熱網/冷凝器的灰塵，確保通風良好
4. 檢查是否過度塞滿食物，影響冷氣循環
5. 確認雪櫃遠離熱源（爐頭、陽光直射）

English Solution：

1. Check if temperature setting is too high, adjust to 4°C (fridge) / -18°C (freezer)
2. Ensure door is fully closed and door seal is not damaged
3. Clean dust from condenser coils for proper ventilation
4. Do not overfill refrigerator to allow air circulation
5. Keep fridge away from heat sources (stove, direct sunlight)

自助處理方法：

1. 檢查冷氣循環風口是否被食物擋住
2. 確認風扇是否正常運作（聽是否有風聲）
3. 清理冷藏室排水孔是否堵塞
4. 檢查溫控器是否故障，嘗試調整溫度設定
5. 暫時關機30分鐘後重啟，讓系統重置

English Solution：

1. Check if air vents are blocked by food items
2. Ensure internal fan is working (listen for fan noise)
3. Clear any blockage in refrigerator drain hole
4. Check thermostat function, adjust temperature settings
5. Turn off for 30 minutes then restart to reset system

自助處理方法：

1. 檢查製冷劑是否洩漏（需專業檢測）
2. 清理散熱器及壓縮機周圍灰塵
3. 確認壓縮機散熱風扇是否正常運作
4. 檢查毛細管是否堵塞
5. 避免頻繁開關雪櫃門，減少冷氣流失

English Solution：

1. Check for refrigerant leakage (professional inspection needed)
2. Clean dust around compressor and condenser
3. Ensure compressor cooling fan is functioning
4. Check for capillary tube blockage
5. Minimize door opening to reduce cold air loss

自助處理方法：

1. 清理冷藏室後方排水孔，可用細線或熱水沖洗
2. 檢查接水盤是否滿水或破裂，及時更換/清空
3. 確認門封條是否損壞，導致結冰融化漏水
4. 檢查製冰機水管是否鬆脫或破裂
5. 調整雪櫃水平位置，確保稍微向後傾斜

English Solution：

1. Clear drain hole at fridge back with wire or hot water
2. Check water collection tray for overflow or damage
3. Inspect door seal for damage causing ice melt leakage
4. Check ice maker water pipe for looseness or damage
5. Adjust fridge level to tilt slightly backward

自助處理方法：

1. 將雪櫃溫度調高1-2度，避免過低設定
2. 檢查門封條是否漏氣，更換損壞的門封
3. 不要將熱食物直接放入雪櫃
4. 定期（每月）除霜，無霜雪櫃檢查除霜系統
5. 確保食物不要貼近冷氣出風口

English Solution：

1. Raise temperature setting by 1-2 degrees
2. Check door seal for air leakage, replace if damaged
3. Do not put hot food directly into refrigerator
4. Defrost monthly (check defrost system for frost-free models)
5. Ensure food is not blocking air vents

自助處理方法：

1. 檢查除霜加熱管是否故障（需專業檢測）
2. 清理冷凍室排水孔，確保排水暢通
3. 檢查溫控器是否失靈，更換故障零件
4. 暫時關閉冷凍室，完全除霜後重啟
5. 確保冷凍室門完全關閉，門鎖正常

English Solution：

1. Check defrost heater for malfunction (professional check)
2. Clear freezer drain hole for proper drainage
3. Inspect thermostat for failure, replace if needed
4. Temporarily turn off freezer, defrost completely then restart
5. Ensure freezer door is fully closed with functional lock

自助處理方法：

1. 檢查電源插頭是否插緊，電源插座是否正常
2. 確認溫控器是否調至正確位置，非關閉狀態
3. 檢查保險絲/斷路器是否跳閘
4. 聽壓縮機是否運作，無聲響可能是壓縮機故障
5. 確認雪櫃通風口完全暢通，無堵塞

English Solution：

1. Check power plug is securely connected and socket is working
2. Ensure thermostat is set correctly (not in off position)
3. Check fuse/circuit breaker for tripping
4. Listen for compressor operation (silence indicates failure)
5. Ensure refrigerator vents are fully unobstructed

自助處理方法：

1. 檢查進水管接頭是否鬆脫，重新接緊
2. 更換老化或破裂的水管
3. 清理製冰機進水口過濾網雜質
4. 檢查製冰機水位感應器是否故障
5. 關閉水源，清空製冰機並徹底清潔

English Solution：

1. Check water inlet pipe connections for looseness
2. Replace aged or damaged water pipes
3. Clean impurities from ice maker inlet filter
4. Inspect ice maker water level sensor for malfunction
5. Shut off water supply, empty and clean ice maker thoroughly

自助處理方法：

1. 檢查嵌入式櫃體通風口是否堵塞，確保散熱空間
2. 確認雪櫃與櫃體之間有足夠散熱間隙
3. 清理散熱器灰塵，嵌入式設計更容易積塵
4. 檢查嵌入式電源供應是否穩定
5. 避免嵌入式空間密不透風，影響散熱

English Solution：

1. Check built-in cabinet vents for blockage, ensure ventilation
2. Ensure sufficient clearance between fridge and cabinet
3. Clean condenser dust (built-in models accumulate dust easily)
4. Check stable power supply for built-in installation
5. Avoid airtight built-in space affecting heat dissipation